Use where single or variable speed operation and 316 Stainless Steel material is desirable. Self-priming, 8 gpm flow, and debris tolerant. Nitrile impeller is ideal for oil based products. Use Neoprene for water and general purpose pumping. Use Viton for hydrocarbons and most solvents. Jabsco offers optional EPDM standard and high pressure impeller kits 7614-0002and 8980-0002 for hygienic applications and some keytone solvents. Use Tungsten Carbide seal when pumping highly corrosive or abrasive fluids. Do not pump gasoline or other flammable liquids. Motor is not explosion proof. DO NOT RUN DRY.
For pumphead only models (30510-3xxx) select NEMA 56C Frame C-Face motor rated at 3/4 HP at 1750 RPM with appropriate service factor. Motor must handle high axial loads. Ball bearing locked against axial movement is recommended. Motor must deliver 1.5 ft-lbs and 4.3 ft-lbs torque minimum in forward and reverse directions respectively. Use only capacitor start motors.
For pedestal mount models (30510-1xxx) operating at 1750 RPM, select 3/4 HP or 1 1/2 HP motor for standard or high pressure impellers respectively, with an appropriate service factor. For high pressure impellers, the motor must supply 3 ft-lbs or 6.9 ft-lbs. of torque minimum for forward and reverse operation respectively.Rated flow is based on Neiprene inpeller pumping water. Reduce rated flow 10% for Nitrile, Viton. EPDM standard impellers. Reduce rated flow 15% for Nitrile, Viton and EPDM high pressure impellers.